Rapid LED

Kit comes with a pre-drilled heatsink that screws directly into the existing BC14 hood, and no soldering necessary!

This retrofit kit will fit seamlessly into your existing Biocube 14 hood (once gutted), and attaches via 4 screws.  With our plug and play system you will not need to solder.  Please note you will need a reef controller or potentiometer + 10V AC Adapter to run the dimmable driver.

• 4.25" x 9" Heatsink drilled/tapped for 12 LEDs and 4 installation holes

• 6 Solderless Cool White CREE XP-G LEDs

• 6 Solderless Royal Blue CREE XP-E LEDs

• 1 Mean Well ELN-60-48P dimmable driver or 1 Mean Well ELN-60-48D dimmable driver

• 2 Plug-n-Play 7 LED Terminal

• 1 Driver Jumper

• 1 Terminal Plug

• 1 Terminal to Terminal Jumper (8")

• 1 tube of Thermal Grease

• 2 water repellent wire nuts (plus 2 non-water repellent wire nuts)

• 1 power cord to attach to the drivers (US + Canada orders only)

• 7 feet of black bulk wire
  

• 7 feet of red bulk wire
  

• 1 zip tie

• Screws (for the LEDs and to mount the heatsink to the hood

• Click here for kit instructions
  

• Click here for plug-and-play instructions
  

• For orders outside the US, please email us first (additional shipping charges may apply)
  
  
• Please note this kit will only fit the Oceanic Biocube 14

If you'd like to change the color ratio please list under "special instructions" at the end of checkout the changes to be made (no additional charge, currently only cool white, neutral white and royal blue are available)